All images © Bob Atkins

15.jpg

This website is hosted by:
Host Unlimited Domains on 1 Account

18.jpg

Welcome, Guest. Please login or register.

Login with username, password and session length
 
Web www.bobatkins.com
*
+  The Canon EOS and Photography Forums
|-+  Photography Forums
| |-+  The Canon EOS Forum
| | |-+  Canon 60Da for astrophotography
« previous next »
Pages: [1]
Print
Author Topic: Canon 60Da for astrophotography  (Read 6005 times)  bookmark this topic!
KeithB
Hero Member
*****
Posts: 543


Canon 60Da for astrophotography
« on: April 03, 2012, 04:54:26 PM »

Logged
klindup
Senior Member
****
Posts: 157


Re: Canon 60Da for astrophotography
« Reply #1 on: April 03, 2012, 05:37:53 PM »

I am curious about one thing.  Most if not all cameras designed specifically for astrophotography use ccd rather than cmos sensors and are cooled by at least 30 degrees centigrade below ambient temperature.  Are here inherent advantages of ccd over cmos for this application?
Ken
Logged
Bob Atkins
Administrator
Hero Member
*****
Posts: 1253


Re: Canon 60Da for astrophotography
« Reply #2 on: April 03, 2012, 08:19:40 PM »

They used to be, but the advantages of CCDs over CMOS have diminished as CMOS technology has advanced.

I think CCDs may still have a slight edge. They have little active circuitry on them so they don't heat up so much in operation for example. They're easier to make since they are less complex.

CMOS is almost as good and much better adapted to use in digital cameras because a lot of the circuitry needed for digital imaging can be built right on the sensor chip itself
Logged
klindup
Senior Member
****
Posts: 157


Re: Canon 60Da for astrophotography
« Reply #3 on: April 04, 2012, 01:51:54 AM »

I take your point about the circuitry.  I guess they are also simpler because many, and certainly the most expensive shoot in monochrome relying on the use of filters and multiple exposures to capture the RGB channels.  That said when you think they have few of the functions of a camera body why are they so expensive?   

Here in the UK we are pretty much limited to exposures of no more than a couple of minutes because any more and you are likely to pick up satellite and aircraft trails.  Registax has made a great difference to astrophotography.  I preface my next question with a very strong warning DON'T DO THIS UNLESS YOU ARE USING SPECIALIST EQUIPMENT AND YOU REALLY KNOW WHAT YOU ARE DOING.  If you are photographing the sun using a Hydrogen Alpha filter, would you get better results with a modified DSLR with the IR filter removed?
Ken
Logged
Bob Atkins
Administrator
Hero Member
*****
Posts: 1253


Re: Canon 60Da for astrophotography
« Reply #4 on: April 04, 2012, 10:13:32 AM »

I presume CCD based cameras and sensors are expensive because they aren't made by the million on a production line like DSLR CMOS sensors are.

If you're using a H Alpha filter on a telescope, that's a very narrow band tuneable filter. I guess your exposure time would be shorter with either the low pass filter removed from the sensor, or with a 60Da vs. a 60D since both will have a stronger response to the H Alpha wavelength. However, if your exposure with the low pass filter installed is short enough not to be a problem, then removing it won't help.

What would help would be a monochromatic camera without a Bayer matrix (or a low pass filter). With a conventional Bayer matrix camera only 25% of the pixels are red, so (unless there is some red response in the green and blue pixels, which there usually is) you only use 25% of the sensor data for H alpha.

Note for those unfamiliar with H Alpha. When an electron makes a particular transition in a hydrogen atom it emits light at a wavelength of 656.28 nm (deep red). Hydrogen is the most abundant element in the universe and is mostly what the sun is made of. Looking at the sun in H Alpha light can show incredible detail in the chromosphere, but it requires a very special (and expensive) filter.
« Last Edit: April 04, 2012, 10:16:05 AM by Bob Atkins » Logged
Pages: [1]    
Print
« previous next »
Jump to: